BELTS

Made of two layers of the finest Wickett & Craig leather, glued and stitched together, they are very close to 1/4" thick.

The standard width of these belts is 1-1/2", but I do make them other widths on request.

The second row of stitching adds another noticeable degree of stiffness to the belt, but I can do just a single row of stitching if you're after a more "dressier" look.

I furnish a brass or silver buckle as shown, and they are attached with Chicago screws, so all that's needed is a screw driver to swap out another buckle if you so choose.

Stitching can be done in white, or to match the dyed leather.

 

            LIFETIME WARRANTY

I am so confindent in the high quality of my belts that I offer the following:

If you should encounter a problem with your belt, let's talk it over. If we determine the problem is due to my workmanship, I will repair or replace the belt.

For these two-layered stitched belts, I charge $57 for up to 44" of belt size....upwards of 44" add $2 per inch.

(plus shipping, usually $6-$8 depending on location)

I can do stamping as requested....we'll discuss to arrive at a additional cost.

I also make a single layer belt, it too is 1/4" thick. Cost is $40 up to 41", plus $1 per add'l inch of belt size.

I'm now able to make up to a 70" belt with my current strap supplier.

Belt and holster with matching embelishments.

Proper way to measure for your belt size is to measure a belt you now wear, from the tip of the buckle, to the hole you now use.

Horsehide belts.....I have now found a source for horsehide that enables me to make belts for just s few dollars more than the cost of a steerhide one.

My horsehide belts are made by laminating the top layer (outside layer) of horsehide to an inside layer of cowhide, then stitched. The result is very close to 1/4" in thickness.

I have determined  that this method of construction makes for a more stable and firmer belt.

Please contact me with your questions or concerns.